Tempo, Modular Cable and Wire Map Tester, LED Display, (1) 9V Battery

The 468-G tester comes with two RJ-45 adapter cords, 468T transmitter and 468R receiver. One 9-V battery is required. This 8-ounce kit measures 7.125 in. x 3.75 in. x 2 in. Most voice and data network problems are wire related. Open or shorted pairs and general miswires are quickly diagnosed with the 468 Modular Cable Tester. The tester features a built-in tone generator, connect any 8-position modular plug to the appropriate jack on the transmitter, and a sweeping-tone signal is applied to all pairs. At the far end of the cable, use any 200-Series Inductive Amplifier to locate the corresponding plug or jack. Connecting the receiver unit automatically activates the test process. Sequencing red and green LEDs provide fast, accurate and easy to understand results. The model identifies open and short circuits, reversed and transposed pairs and alerts if connected to an active circuit, without harming the unit.

Identify open, short, reversed and transposed pairs

Send tone to identify cable at remote

Shielded ports test both shielded and unshielded cabling

Specifications

Power: One 9V battery, nominal life 2000 hrs (no load)

Tone frequency: 850 and 950 Hz alternating nominal Tone output: 9V p-p open circuit Voltage protection: Transmitter - 52 V dc 90 V p-p (up to 10 minutes); Receiver - 52 V dc momentary

There are currently no resources for this product.